Category, Fluid Accessories

One way valve with barbed adapters. Small, five inches long, and lightweight.

Code #: H2900 – ‘Heimlich’ Valve

[...]
Universal spike, 224cm (88in) tubing, roller clamp, slide clamp, one injection site located 11 inches above distal end, spin connector. Priming volume = 25.6ml Code: 175250 Universal spike, 261cm (103in) tubing, roller clamp, slide clamp, two injection sites located 9 inches and 87 inches above distal end, spin connector. Priming volume = 28ml Code: 175255   Read more [...] [...]
Administration set with vented spike, 76 inch tubing (190cm), drip chamber, rotating luer lock, roller clamp and injection site. Replacement for the discontinued BD15 Drop Set. Priming Volume = 13.3ml Code: 175278 Read more [...] [...]
No image

Description: A pressurised cuff for rapid intravenous infusion and other occasions where fluid under pressure is required e.g irrigation of op side or wounds.  The cuff has the capacity for up to 1 litre and is easy to use with high quality dial and inflation system, simple to use and load with zip fastenings.

[...]
No image

Description: A large bore coiled giving set for multi-bag infusion of fluids in large animal and equines.

Tubing Diameter: 5mm

Tubing Length: 4280mm (14ft)

Drops per ml: Distilled Water Approx 12.5 (All Rates up to 150 drops per minute)

Filter Size: N/A

[...]
No image

Description: A 2 into 1 set which provides an easy and reliable method of delivering IV fluids from two seperate fluid containers, either in series or parallel.

Tubing Diameter: 3mm

Tubing Length: 2300 (7.5ft)

Drops per ml: Distilled Water 20

Filter size: 15 MICRON

[...]
 A standard solution administration set for day to day infusion of fluids. Tubing Diameter: 3mm Tubing Length: 1750mm (5ft) Drops per ml: Distilled Water = 20 Filter Size: 15 MICRON Read more [...] [...]
Description: A combination of a 150ml burette chamber with a 60 drop/ml chamber for accurate delivery of small quantities on standard or pre mixed fluids. Tubing Diameter: 3mm Tubing Length: 2000mm (3.5ft) Drops per ml: Distilled Water 60 Filter Size: 15 MICRON Read more [...] [...]
Description: Where access to the vein is limited and it is desirable to reduce trauma at the insertion site, a T-Connector may be used to maintain the integrity of the insertion site.  Reduced bulk at the site of insertion makes tapping extremely simple in small animals. Read more [...] [...]

Description: Forming loops in tubing particulary leading away from the injection sites can be difficult without kinking.  The resistor holds a permanent loop in the tubing.

[...]
No image
Description: Your bag of Aqupharm fluid begins to cool as administration begins.  In most situations the fluid will have cooled considerably before the infusion is completed.  The Aqupharm heat retention jacket asssists the fluid to retain their temperature for several hours.  It can even be re-heated during the infusion to extend its effectiveness. How Does It Work? The inner jacket conatins a cereal based filler which is heated in a microwave and will retain its heat for several hours.  Read more [...] [...]
No image

Description: A combination of a 150ml burette chamber with a 60 drop/ml chamber for accurate delivery of small quantities on standard or pre mixed fluids but now with the added advantage of an AccuRate dial up controller to make setting quicker and easier.

Tubing Diameter: 3mm

Tubing Length: 1950mm (6.5ft)

Drops per ml: Distilled Water 60

Filter Size: 15 MICRON

[...]
Reliable guidewire introduction technique. 22Ga x 6cm (2.5in) Constructed of PTFEm with flexible suture wing. Set includes 22Ga needle, wire, and catheter.

Code: AR2206- Arterial Catheter

[...]
High flow infusion set includes spike, 10 feet of tubing, clamp, and spin luer lock. Fits basic peristaltic pump. DESCRIPTION                                                                                                    CODE # Tubing -10 feet (300cm)                                                                                         175499 Read more [...] [...]
Deliver topical anesthetic to the nose, throat, hypo pharynx, vocal cords, larynx, and trachea prior to airway manipulation such as intubation, endoscopy, rhinoscopy, and soft palate exam. The benefit is a reduced gag and sensation, reducing pulse, and blood pressure response to intubation. Atomize medication into a fine mist of particles 50-80 microns. 15Fr (4.7mm) tip x 6.5 inch (15cm) malleable, conformable tube for targeted deposition of medication. 5cc syringe is recommended for accurate Read more [...] [...]